How To Unclog The Toilet’s Pipe: Check Some Tips

Share the love

A completely clogged pipe must be the object of rapid intervention. You try a liquid un-blocker but the result is not very convincing and in addition, it pollutes a lot. Here are some tips and tricks for dealing with how to unclog toilet when nothing works before hiring the plumber

Also Read: Types of plumbing pipes

The hanger trick

Take a regular wire hanger and straighten it as you can. Then bend one end to create a small hook. Remove the cover from your pipe and start fishing. You should be able to get all kinds of “material” and different residues that have clogged your pipe. Once you’ve collected as much residue as possible, pour hot water down the drain. Thus, you can once again have a pipe free of any obstacle.

Baking soda and vinegar

This solution will immediately emulsify and you will need to pour it quickly into the blocked pipe. The kneading action will help remove trash, hair, and grime that has built up in the drain. Let the mixture sit for an hour or even overnight if possible. Rinse it off with warm water. Otherwise, pour as much baking soda as you can down the drain first, then pour in the vinegar. The effect obtained will be identical.

The wet and dry vacuum

If you have a wet and dry vacuum, it can be a great tool for unblocking your drain. First, put it under vacuum. Next, create a joint as tight as possible on the pipe. You can try to adapt an old diver’s head for this purpose. With the vacuum turned to its highest setting, the suction may be powerful enough to pull the plug out of the line. It doesn’t always work, but it’s worth a try toilet’s pipe.

The boiling water technique

Boil water and slowly pour it down the drain in two or three stages, allowing the hot water to work for several seconds between each pour. This is usually the easiest and fastest way to unblock a blocked pipe.

The use of caustic soda

For this tip, consider using rubber gloves and eye protection. Caustic soda (also known as sodium hydroxide) or Saint Mark’s lye can cause nasty chemical burns. You should therefore always exercise caution when handling it. Pour 3/4 liter of cold water into a bucket, then add 3 cups of caustic soda. Stir well with an old wooden spoon. The mixture will then begin to emulsify and heat. Pour into the clogged pipe and leave to act for 20-30 minutes toilet’s pipe, then rinse your pipe with boiling water. Repeat the operation if necessary.

Pipe cleaning

Place an empty bucket under the U-pipe (trap) under the sink. The bucket will collect the water which will spill out. Using a plumber’s wrench, loosen the nuts at both ends of the pipe. You will need to be able to complete the operation by hand. When the trap is free, remove it and turn it over, empty the contents into the bucket. You may also need to dig out some plumbing problems debris inside the piping. An old toothbrush is a good idea for removing hard dirt. Rinse the trap with water and replace it.

Salt and baking soda

Mix 1/2 cup of table salt with 1/2 cup of baking soda and pour into the blocked drain. Let it all sit for 10-20 minutes, then pour in boiling water. Salt, baking soda, and boiling water all produce a chemical reaction that should dissolve some of the more persistent wastes.

Nothing could be easier than dishwashing liquid

If your toilet is clogged, pour 1/4 cup of dish soap into a bowl. Then boil some water. Dish soap acts as a lubricant and helps break down grease residue toilet’s pipe. Run off the washing-up liquid then pour in the hot water.

Baking soda, vinegar, gravity and good pressure

If your shower or tub drain is clogged, mix some baking soda with vinegar. Pour it into your pipe, then place the cap on it. After 45-60 minutes, fill the tub with water. Then remove the cap. The water pressure should be enough to loosen the blockage that has been loosened by the baking soda and vinegar. You can also try unblocking with an un blocker or snake drainage in conjunction with the weight of the water.

Snake drainage

Also known as the drain auger, this tool is a coiled snake-like cable that is usually about 1 to 2 inches in diameter with a handle on one end. It works in the opposite way to that of a diver. You push the snake into the hoof and turn the crank to lead the snake further into the obstruction. As some parts of the obstruction break off and flow through the toilet’s pipe, the snake helps you access the hoof so you can pull it out. Some snakes can fit on an electric drill, giving it more power to force it through the hoof. Snakes are particularly effective because they are long enough to reach distant hooves in a pipe.


Share the love

One thought on “How To Unclog The Toilet’s Pipe: Check Some Tips

Leave a Reply

Your email address will not be published. Required fields are marked *